Compliance notices
Australia and New Zealand
AS/NZS 4268, AS/NZS CISPR 32
This product conforms with the regulatory requirements of the Australian Communications and Media Authority (ACMA) Radiocommunications Act.
Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
-
This device may not cause interference.
-
This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be chosen so that the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This apparatus complies with Canadian RSS-GEN, RSS‑102,
Cet appareil est conforme à la norme CNR-GEN, CNR‑102,
Chile
No label/notice is required.
Eurasian Economic Union (Kazakhstan, Armenia, Kyrgyzstan, Russia, Belarus)
European Union
Hereby, Trimble Inc., declares that the R980 receiver complies with the following directives:
-
RED 2014/53/EU
-
EN 300 113, EN 300 487, EN 300 328, EN 301 908, EN 303 413
-
RoHS Directive 2011/65/EU
-
WEEE Directive 2012/19/EU
CE Declaration of Conformity
The products covered by this guide may be operated in all EU member countries (BE, BG, CZ, DK, DE, EE, IE, EL, ES, FR, HR, IT, CY, LV, LT, LU, HU, MT, NL, AT, PL, PT, RO, SI, SK, FI, SE), Norway, and Switzerland. Product has been tested and found to comply with the requirements for a Radio Equipment device pursuant to European Council Directive 2014/53/EU on EMC, thereby satisfying the requirements for CE Marking and sale within the European Economic Area (EEA). Contains a Bluetooth radio module. These requirements are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential or commercial environment.
Hereby, Trimble Inc., declares that the GNSS receiver is in compliance with the essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU.
English |
Hereby, Trimble Inc., declares that this receiver is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. |
Finnish |
Trimble Inc.vakuuttaa täten että vastaanotin tyyppinen laite on direktiivin 2014/53/EU oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen. |
Dutch
|
Hierbij verklaart Trimble Inc. dat het toestel ontvanger in overeenstemming is met de essentiële eisen en de andere relevante bepalingen van richtlijn 2014/53/EU. Bij deze verklaart Trimble Inc. dat deze ontvanger voldoet aan de essentiële eisen en aan de overige relevante bepalingen van Richtlijn 2014/53/EU. |
French
|
Par la présente Trimble Inc. déclare que l'appareil récepteur est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 2014/53/EU. Par la présente, Trimble Inc. déclare que ce récepteur est conforme aux exigences essentielles et aux autres dispositions de la directive 2014/53/EU qui lui sont applicables. |
Swedish |
Härmed intygar Trimble Inc. att denna mottagare står I överensstämmelse med de väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 2014/53/EU. |
Danish |
Undertegnede Trimble Inc. erklærer herved, at følgende udstyr modtager overholder de væsentlige krav og øvrige relevante krav i direktiv 2014/53/EU. |
German
|
Hiermit erklärt Trimble Inc., dass empfänger in Übereinstimmung mit den grundlegenden Anforderungen und den anderen relevanten Vorschriften der Richtlinie 2014/53/EU befindet". (BMWi) Hiermit erklärt Trimble Inc. die Übereinstimmung des Gerätes empfänger mit den grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtlinie 2014/53/EU. (Wien) |
Greek |
ΜΕ ΤΗΝ ΠΑΡΟΥΣΑ Trimble Inc ΔΗΛΩΝΕΙ ΟΤΙ δέκτης ΣΥΜΜΟΡΦΩΝΕΤΑΙ ΠΡΟΣ ΤΙΣ ΟΥΣΙΩΔΕΙΣ ΑΠΑΙΤΗΣΕΙΣ ΚΑΙ ΤΙΣ ΛΟΙΠΕΣ ΣΧΕΤΙΚΕΣ ΔΙΑΤΑΞΕΙΣ ΤΗΣ ΟΔΗΓΙΑΣ 2014/53/EU. |
Italian |
Con la presente Trimble Inc. dichiara che questo ricevitore è conforme ai requisiti essenziali ed alle altre disposizioni pertinenti stabilite dalla direttiva 2014/53/EU. |
Spanish |
Por medio de la presente Trimble Inc. declara que el receptor cumple con los requisitos esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 2014/53/EU. |
Portuguese |
Trimble Inc. declara que este receptor está conforme com os requisitos essenciais e outras disposições da Directiva 2014/53/EU. |
Recycling
For product recycling instructions and more information, go to trimble.com/en/our-commitment/responsible-business/product-compliance/environmental-compliance.
India
Government of India, Ministry of Communications, Department of Telecommunications
Japan
日本
総務省 技術基準適合証明済み
R D180136003 (LTE) と R 003-180238 (LTE)
R 201-140447 (BT/Wi-Fi)
R 202-220089 (403MHz - 473MHz, バヨネット) また R 201-020023 (403MHz - 473MHz, 短剣)
Korea
South Africa
This product was type approved by the Independent Communications Authority of South Africa.
Taiwan
台灣

取得審驗證明之低功率射頻器材,非經核准,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
低功率射頻器材之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。
前述合法通信,指依電信管理法規定作業之無線電通信。低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
-
應避免影響附近雷達系統之操作
-
高增益指向性天線只得應用於固定式點對點系統
電磁波功率密度MPE標準值: 1 mW/cm2,送測產品實測值: 0.024 mW/cm2,建議使用時設備天線至少距離人體20公分。
United Arab Emirates
Telecommunications and Digital Government Regulatory Authority
United Kingdom
Hereby, Trimble Inc., declares that the R980 receiver complies with the following UK legislations:
-
S.I. 2016 No. 1101, Low Voltage, RF Exposure
-
S.I. 2016 No. 1091, EMI/EMC
-
S.I. 2017 No. 1206, Radio Equipment
USA
COCOM limits
This notice applies to the R980 receiver.
The U.S. Department of Commerce requires that all exportable GPS products contain performance limitations so that they cannot be used in a manner that could threaten the security of the United States. The following limitations are implemented on this product:
– Immediate access to satellite measurements and navigation results is disabled when the receiver velocity is computed to be greater than 1,000 knots, or its altitude is computed to be above 18,000 meters. The receiver GPS subsystem resets until the COCOM situation clears. As a result, all logging and stream configurations stop until the GPS subsystem is cleared.
FCC compliance statement
Part 15 Subpart B (Class B), Subpart C, Section 15.247, Part 90, Part 22/24/27, Part 2, KDB 447498 D01
Regulatory model numbers:
R980
FCC Class B - Notice to Users. This device complies with part 15 of the FCC rules.
RESPONSIBLE PARTY:
Trimble Inc.
10368 Westmoor Drive
Westminster CO 80021
USA
www.trimble.com/Corporate/Contacts.aspx
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved by Trimble Inc may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm (for Bluetooth) from all persons and must not be co-located or operated in conjunction with any other antenna or transmitters (except in accordance with the FCC multi-transmitter product procedures).
FCC Certified Modular Transceiver
The Thales PLS63-W (P/N 124213), Singular-Modular Transceiver (LTE) was tested and certified per FCC Part 22, 24, 27, (FCC ID: QIPPLS63-W) with an internal antenna not accessible by the user.
The Texas Instruments WL1837MODGIMOC (P/N 103488), Singular-Modular Transceiver (Wi-Fi/BT) was tested and certified per FCC Part 15C (FCC ID: Z64-WL18DBMOD) with an internal antenna not accessible by the user.
The TR400900 (P/N 123130), Singular-Modular Transceiver (410 MHz to 470 MHz / 902 MHz to 928 MHz) was tested and certified per FCC Part 15.247 and Part 90 (FCC ID: S9E123130) for use with the antenna listed below:
-
A monopole antenna with peak gain of 1.85 dBi (410 MHz to 470 MHz) and 3.28 dBi (902 MHz to 928 MHz) and RP-SMA connector (P/N 129988).
-
A monopole antenna (P/N 24253-xx) with peak gain of 5.0 dBi (410 MHz to 470 MHz / 902 MHz to 928 MHz) and 5 m RG58 cable with RP-SMA connector (P/N 130626-05).