MSS Status

This page provides information about the currently-tracked Trimble RTX correction service (with xFill technology).

Select MSS Corrections / Status.

 

RTX/xFill Configuration

SV name – Displays the name of the CenterPoint RTX/xFill satellite currently being tracked. "Auto" indicates that the satellite was selected based on geographical location.

Frequency [MHz] – Displays the frequency of the currently-tracked RTX/xFill satellite.

Bit Rate [Hz] – Display the rate at which the tracked RTX/xFill data is modulated to the carrier wave.

L-Band Beam Status

Mode

• Off – Signal tracking is off.

• Search – Initializing – Searching for RTX satellite, initializing.

• Searching – Searching for RTX satellite, running.

• Tracking – Initializing – Found RTX satellite, tracking initialization.

• Full Tracking – Found RTX satellite, verifying data stream.

• Full Tracking (Service) – Fully tracking RTX satellite and using the service indicated in the brackets.

SNR [dBHz] – Signal-to-Noise ratio (SNR) of RTX signal.

Link % – Displays the packet success rate. 100% indicates that no packets have been dropped.

Age of Correction [sec] – Displays the age of corrections in seconds.

Status – The RTX Status field reflects if the receiver is being used in a zone that is restricted to Trimble RTX correction services. Only available when RTX is enabled.

0 is Unknown

1 is Not Restricted (for land-based applications)

2 is Restricted

Eb/No [dB] – Signal strength.