Starting the instrument

NOTE – Before following any of the instructions below, put the instrument in the face 2 position, i.e. the telescope eyepiece and face 2 keyboard and display are pointing towards you.

The face 2 display menus described in this section can only be accessed when there is no T70 attached; remove the T70 before starting the instrument.

  1. Start the instrument by pressing the On/Off key.

    Once you start the instrument, the Select Mode menu appears in the face 2 display.

    If no key is pressed for more than 10 seconds, the instrument will return to the Waiting for connection screen, displaying the selected radio Channel and Network ID.

  2. To go to setup & level press to scroll to Setup/Level and then press .

  3. From the Select Mode menu you can set up the remote operating mode Site Positioning.

    In this mode, the instrument operates with a slower data update rate and is not fully optimized for dynamic positioning applications. This mode is suited to measurements while standing still, walking, vehicle or measuring with DR reflectorless capabilities.

    The current mode of operation can be broken by returning to the instrument and tapping the trigger/on/off key. This process will terminate any live user and make the instrument available.

  4. To set up the instrument for Site Positioning, press to scroll to Site Positioning and then press .

  5. After the selection the instrument will go to suspend mode. To return to the Select Mode menu press the trigger/on/off key.

The instrument is now setup for Site Positioning with the radio set as base station.

NOTE –

  • If no selection is made within 10 seconds the instrument will go to suspend mode. To return to the Select Mode menu press the trigger/on/off key.

  • If no selection is made the last highlighted mode will be used.