GNSS menu
When a GNSS is connected to Siteworks, use this menu to connect to the rover receiver, carry out a site calibration, and select a predefined coordinate system if a calibration has not yet been performed. You can also recheck the system setup on a control point.
From the Home menu, tap Project Setup.
The following commands are available:
|
Command |
Description |
|---|---|
|
|
Set up and start a GNSS base station, rover receiver, or start the internal GNSS of the controller. |
|
|
Select a predefined coordinate system from the coordinate system library. This option is only available for sites that have not been calibrated or do not yet have a coordinate system assigned. |
|
|
Perform or resume a single-point, two-point, or multi-point site calibration, and review the calibration when it is completed. |
|
|
Check the existing site calibration and base station location by checking in on a known control point. |
