Managing application files
SPS modular receivers only.
For the SPS356 modular GNSS receivers, see Managing application files.
You can use the front panel to manage application files in the receiver. You can see which application file the receiver is currently using and then choose to make changes to it and save it, load a different application file, or delete an application file.
To manage the application files, use the System Setup menu (see the figure below). You can only manage application files when the AutoBase feature is turned off.
To save an application file, configure all the settings you need through the front panel and then save the file. When you save the file, the receiver provides a default filename, which you can change, based on the currently set mode. For example:
|
Receiver mode |
Suggested application file name |
Notes |
|---|---|---|
|
Base |
BASE01 |
Does not apply to the SPS555H receiver. |
|
Heading |
HDG01 |
|
|
Moving Base |
MB01 |
Does not apply to the SPS555H receiver. |
If you start an application file that is saved with AutoBase turned on in the file, then it turns on AutoBase in the receiver, even if it was off before the file was loaded.
The following figure shows how application files are handled through the front panel of the receiver:
