Receiver Configuration – Summary

This page displays the current settings of the receiver.

Select Receiver Configuration / Summary.

 

Elevation Mask – The elevation mask below which the receiver will not track satellites.

PDOP Mask – The value for PDOP above which the calculation of new positions is suspended until the PDOP falls below the mask value again.

Horizontal Precision – The required horizontal precision that you set to determine when the horizontal quality indicator on the receiver display switches from flashing (precision threshold not met) to not flashing (precision threshold met). It also determines when an OmniSTAR solution has initialized.

Vertical Precision – The required vertical precision that you set. This threshold determines when the vertical quality indicator on the receiver display switches from flashing (precision threshold not met) to not flashing (precision threshold met).

Clock Steering – When enabled, the receiver clock is steered to GPS system time rather than periodically introducing 1 ms steps and constraining the clock to ± 0.5 ms. Enabled by default.

EVEREST™ Multipath Mitigation – Trimble proprietary multipath mitigation algorithm. Enabled by default.

Signal Tracking Bandwidth – Can be Wide or Narrow. The default is Narrow.

Antenna ID – The numeric ID of the selected antenna type being used with the receiver.

Antenna Type – The selected antenna type being used with the receiver.

Antenna Measurement Method – Shows how the antenna height is being measured. The following methods define how the antenna height was measured. The usual method is to measure to the “Bottom of antenna”.

Antenna Height – The height of the antenna reference point. This is set in the Antenna Configuration screen.

1PPS On/Off – Indicates the state of the 1PPS output on Serial 3 port.

RTK Mode – Indicates if the receiver is in a synchronized or low latency RTK mode.

Receiver Motion – Indicates if the receiver is set to operate as a static or kinematic receiver. This mode determines if the unit is Static or Moving for base station applications and MSS (RTX or OmniSTAR) initialization.

CMR Input Filter – Shows whether or not CMR corrections are being used from a specific base station.

Reference Latitude – The WGS-84 reference station latitude.

Reference Longitude – The WGS-84 reference station longitude.

Reference Height – The WGS-84 reference station ellipsoid height.

RTCM 2.x ID – A unique identifier for the RTCM messages. Can be any value from 0 through 1023.

RTCM 3.x ID – A unique identifier for the RTCM messages. Can be any value from 0 through 4095.

CMR ID – A unique identifier for the CMR message. Can be any value between 0 through 31.

Station Name – The sixteen-character name of the reference station.

Ethernet IPv4 Address – The Ethernet IP address of the receiver.

System Name – The unique system name for the receiver.

DNS Resolved Name – The name returned by the DNS system.

Serial Number – The serial number of the receiver.

Firmware Version – The version of the firmware currently installed in the receiver.

Firmware Date – The production date of the firmware currently installed in the receiver.