LEDs
There are four LEDs. The LEDs light up as follows:
|
LED |
Color |
Indication |
|---|---|---|
|
PWR |
Continuous Red |
Correct voltage applied to radio, radio off |
|
|
Continuous Green |
Correct voltage applied to radio, radio on |
|
|
Blinking Red |
Unacknowledged alarm |
|
|
Blinking Blue |
Waiting for a Bluetooth device to connect |
|
Blinking Red |
Connectable but not in pairing mode |
|
|
Continuous Blue |
Bluetooth connected |
|
|
Tx |
Continuous Red |
Transmitting |
|
|
Continuous Green |
Transmit test active |
|
Rx |
|
Receiving when lit |
If the Power LED is blinking RED, an alarm has been raised in the radio. This requires your attention to understand and correct the problem. Trimble recommends attending to alarms before continuing use of the radio. The display also shows 
on the top row.
On the main display, you can press the Back button to access the Alarm list. You can also use the Device Settings / Alarm list to access the menu. Once in the Alarm list menu, you can acknowledge the alarm by selecting it and pressing OK. You can then acknowledge the alarm only, clear the alarm, or clear all alarms. Acknowledging the alarm stops the power LED from blinking red, but also keeps the alarm in the memory for future troubleshooting.
