Set up in the office

You need the following equipment:

  • A TDL450B radio.

  • A power cable (TDL450B power cable P/N 130919).

  • An 11 V to 30 V power source with an SAE connector protected by a 20 Amp fuse.

  • Optionally, a data cable if not using Bluetooth technology (TDL450B USB Type A data cable P/N 130927)

  1. Connect the SAE connector of the TDL450B power cable to the Office power kit SAE connector and to the radio with the 2-pin LEMO connector.

  2. If you are not connecting using Bluetooth, plug the LEMO connector of the data cable to the serial data port on the radio. Connect the USB Type A data cable to your computer.

    On rare occasions, the radio may not be recognized by the computer, especially when using a USB hub. Please plug cable P/N 130927 directly into the computer or use an alternative USB hub if you encounter connection problems.

  3. Plug the office power kit into the wall. Always check that all cables are connected before connecting power to the radio.

    If you are powering the radio with a battery, disconnect any battery charger from the battery.

  4. If you are using the Bluetooth connection, pair the computer with the radio.

  5. You can now use the radio with the Trimble Access software, Siteworks software, or Trimble Installation Manager.