Specifications
Radio
Specifications are subject to change without notice.
Available model: TDL510 with display, P/N 130510-50
|
450 MHz radio |
|||
|---|---|---|---|
|
|
Receiver |
Transmitter |
Notes |
|
Frequency range |
410 to 470 MHz |
|
|
|
Tuning range |
63 MHz |
|
|
|
Minimum RF frequency step |
6.25 kHz |
|
|
|
Channel bandwidth |
12.5 kHz, 25 kHz |
|
|
|
Frequency stability |
±0.5 ppm |
-40 °C to +85 °C (reference to +25 °C) |
|
|
Modulation |
4-GFSK, GMSK (depending on protocol or compatibility mode) |
|
|
|
Maximum receiver input power without damage |
+3 dBm |
|
|
|
Maximum receiver input power without transmission errors |
-10 dBm |
|
|
|
Sensitivity 1 BER = 10-2 |
typ. -113 dBm typ. -115 dBm |
|
|
|
Transmitter power |
|
1 W |
|
|
Communication mode |
Half-Duplex |
|
|
1 According to EN 300 113, V2.2.1 measurement setup.
|
900 MHz radio |
||
|---|---|---|
|
|
Receiver |
Transmitter |
|
Frequency range |
902 to 928 MHz |
|
|
Spreading method |
Frequency hopping |
|
|
Occupied bandwidth |
230 kHz |
|
|
Frequency stability |
< 1 kHz |
|
|
Maximum receiver input power without damage |
+10 dBm |
|
|
Maximum receiver input power for error rate <50% |
+6 dBm |
|
|
Sensitivity |
typ. -109 dBm for BER 10-2 |
|
|
Transmitter power |
|
27, 30 dBm |
|
Carrier power stability |
|
< -3 dB |
|
Symbol rate |
127.38 ksps |
|
|
Modulation method |
BPSK |
|
|
Hopping frequencies |
50 |
|
|
Hopping patterns |
40, selectable |
|
|
Data speed of serial interface |
115200 bps |
|
|
Electrical interface |
Port 1: RS-232 |
|
Interface connector |
D-15 (female) |
|
Data speed of serial interface |
1200 to 115200 bps |
|
Serial interface parameters |
8N1 |
|
Data speed of radio interface |
4FSK: 19200 bps (25 kHz) GFSK: 9600 bps (12.5 kHz) BPSK: 115200 bps |
|
Data format |
Asynchronous data |
|
General |
|
|---|---|
|
Operating voltage range |
+7 to +27.5 V DC (-15 % / +20 %) As a result of a new revision of safety standard IEC600001, voltage range is marked to a label with tolerance limits. The functionality cannot be guaranteed if you use the device beyond this region. |
|
Absolute MAX voltage |
+33 V (exceeding the value may damage the device) |
|
Power consumption |
Receiver: MAX 2 W, typical <1.5 W @ 12 V Transmitter @1 W output: MAX 6 W, typical <5.5 W @ 12 V DTR OFF: MAX <50 mW, typical <10 mW @ 12 V |
|
Temperature ranges |
-20 °C to +55 °C type approval conditions -30 °C to +70 °C functional (the functionality cannot be guaranteed if you use the device beyond this region.) -40 °C to +85 °C storage (recommended storage is at dry, room temperature.) |
|
Antenna connector |
TNC female 50 Ohm |
|
Construction |
Aluminum housing |
|
IP rating |
IP44 |
|
Size |
138.5 mm (length) × 67 mm (width) × 28.5 mm (depth) |
|
Weight |
< 350 g |
|
Compliant with international standards |
|
|---|---|
|
RF requirements |
FCC CFR47 Part 90 and KDB 971168 D01, Part 15.247 and KDB 558074 D01 |
|
EMC requirements |
EN 301 489-1 and -5 (8 kV contact, 15 kV air discharge) |
|
Safety standard |
IEC 62368-1 |
|
Immunity |
EN 61000-4-3 (2006) (10 V/m) |
Antenna
450 MHz / 900 MHz 6" UHF antenna (P/N 123588).
|
Connector |
RP-TNC Male |
|
Frequency ranges: |
410 MHz to 473 MHz, 868 MHz to 928 MHz |
|
Polarization |
Vertical |
|
Power |
1 W 450 MHz, 1 W 900 MHz |
|
Gain |
1 dBi (410 MHz to 473 MHz), 1 dBi (868 MHz to 928 MHz) |
|
Type of antenna |
Monopole |
Radiation pattern at 450 MHz
Radiation pattern at 915 MHz
