Mines

Enhancements

Blast hole selection

Trimble Access 2024.10 provides the following enhancements to make blast hole selection easier:

• The Blast hole definitions list now appears alongside the map so that you can see the selected points on the map.

• Changes you make to the list of selected points, point order, or line direction from the list are reflected in the map.

• To manually reorder the points, you can now tap them in the list and drag them up or down.

• You can remove any points from the list that do not require staking. Press Ctrl to select more than one point at a time and then tap Remove. To remove several points at once you can select a point in the list and then tap Remove ↓ or Remove ↑ to remove all points below or above the selected point in the list.

Resolved issues

• Blast hole names: We have fixed an issue where Trimble Access was incorrectly modifying the names of blast holes imported from Surpac files.

• Application errors: We have fixed several issues that caused occasional application errors when using or closing the software. In particular:

  • After tapping the column header to reorder blast holes and then tapping the Swap softkey to reverse the direction of the blasthole.