Length measurement

When you select a length measurement request from the Measure requests list the software shows the map and the Measure length form.

1. Select points from the list or map view.

   As points are selected they are given a number based on selection order and highlighted blue in the map. Tap a point again to remove it from the current selection. To clear the current selection and start again, tap None.

2. If the points you want to use do not yet exist in the job then tap the Measure softkey to open the Measure points form and measure new points.

   For more information, see Pour mesurer un point topo.

   Once you have measured the new points, tap Esc in the Measure point form to return to the Measure length form and then select the points from the list or the map.

3. Tapez Calc. The Measurement request result screen appears

   The Shared length group box shows the value that will be displayed in the Infotech Mobile Inspector web application and used for payment calculations. Select from the following options::

   • Slope Length: The distance measured along an inclined surface such as a road or hill.

   • Horizontal Length: The distance projected onto a flat, horizontal plane, disregarding elevation or slope.

   The Measurements group box displays the calculated values.

   • Selection: Lists the points selected for the length calculation.

   All of these values are stored in a LandXML file for use in office software and for auditing purposes.

4. To add an additional length to the final shared value, tap the + softkey to open the Measure length form.

   Points added to the calculation are shown in the Measurement request result screen in the Selection list after the semi-colon.

5. To complete the measure request, tap Share.

   All of the information shown in the results screen and the attached LandXML file are shared with Infotech Mobile Inspector and the Daily Work Report.