To collect a line or polygon iFeature

  1. Tap . If the Measurement mode bar does not show this button, touch-hold to change it to .
  2. In the Topo screen, tap Select iFeature.

  3. In the Add dialog, select the iFeature category and then the iFeature type to add to the iFeature action bar.

    The name of the selected iFeature type and the Line type button appears on the iFeature action bar.

  4. To change the line type, tap the Line type button and then select one of the following:

    Icon Name Requires you to collect...
    Polyline At least two nodes.
    Curve At least three nodes.
    Arc At least three nodes.
    Circle 1 point One node in the center of the circle and a radius value.
    Circle 2 point Two nodes: one node in the center of the circle and one node on the edge.
    Circle 3 point Three nodes on the edge of the circle.
    Rectangle 2 point Two nodes along one side of the rectangle and a height value.
    Rectangle 3 point Three nodes: two nodes along one side of the rectangle and one node on the opposite side.
  5. Select the survey method from the Survey methods bar and then perform the appropriate steps to add the required number of nodes to the map for the iFeature.
  6. If more information is required, such as a radius or height value, a dialog appears on-screen. Enter the required value and tap OK.
  7. To add a GIS record, tap . Fill out the GIS record form for the iFeature and then tap OK.
  8. To add a photo to the iFeature, the GIS record must include a defined photo attribute. To add the photo:
    1. Tap the photo attribute to open the photo capture screen:
    2. To change the image resolution, tap the resolution button at the top left of the screen.
    3. To change the image quality, tap the image compression button at the top right of the screen.
    4. To capture the image, tap the capture button below the camera view.
  9. To end the iFeature, tap the End line or Close polygon button.

To Undo the previous action, drag left across the iFeature action bar. To Redo the edit, drag right across the iFeature action bar.

To collect another iFeature of the same type, repeat steps 4 through 9.

To stop collecting iFeatures of the selected type, tap the iFeature type name in the iFeature action bar and then tap Remove.