To collect a point iFeature

  1. Tap . If the Measurement mode bar does not show this button, touch-hold to change it to .
  2. In the Topo screen, tap Select iFeature.

  3. In the Add dialog, select the iFeature category and then the iFeature type to add to the iFeature action bar.

    The name of the selected iFeature type and the Point button appears on the iFeature action bar.

  4. Select the survey method from the Survey methods bar and then perform the appropriate steps to add a node to the map for the point.
  5. If more information is required, such as a radius or height value, a dialog appears on-screen. Enter the required value and tap OK.
  6. To add a GIS record, tap . Fill out the GIS record form for the iFeature and then tap OK.
  7. To add a photo to the iFeature, the GIS record must include a defined photo attribute. To add the photo:
    1. Tap the photo attribute to open the photo capture screen:
    2. To change the image resolution, tap the resolution button at the top left of the screen.
    3. To change the image quality, tap the image compression button at the top right of the screen.
    4. To capture the image, tap the capture button below the camera view.

To Undo the previous action, drag left across the iFeature action bar. To Redo the edit, drag right across the iFeature action bar.

To collect another point iFeature of the same type, repeat steps 4 through 7.

To stop collecting iFeatures of the selected iFeature type, tap the iFeature type name in the iFeature action bar and then tap Remove, or select a different iFeature.