Changing device settings

When a new Trimble Sentinel hardware device is purchased and assigned to an email address, it appears in that account owner's device list. Use the Devices tab on the Settings screen to apply settings to one or more devices.

NOTE – A geofence must be created before it can be assigned to a device. You can set up the device without assigning a geofence and assign one later. See Creating geofences.

To change device settings

  1. Select Settings in the side navigation.

  2. Select the Devices tab.

  3. Select one or more devices in the table.

  4. Set Position Update Frequency, Minimum Distance Threshold, Impact Threshold, and Geofenceassignment as needed.

  5. Click Apply.

Setting Options What it does
Position Update Frequency Off, 15 min, 30 min, 1 hr, 2 hr, 6 hr, 12 hr, or Daily Controls how often the Sentinel module transmits its current GNSS position.
Minimum Distance Threshold Off, 50 m, 100 m, 200 m, 500 m, or 1 km If the device moves further than this distance from its last recorded position, it immediately updates its position.
Impact Threshold Disabled, Light Fall (1–2G), Strong Fall (2–3G), Serious Fall (3–4G), Deadly Fall (4–5G), or Possible Crash (5G+) If the device experiences a physical impact exceeding the threshold, it immediately updates its position and can send an alert.

TIP – For active job sites, a higher threshold (Serious Fall through Possible Crash) reduces alert noise. For sensitive instruments in transport, use Light Fall or Strong Fall for earlier notification.

Applying geofence changes on this tab sets the selected geofence list on all selected devices.