Power supply
A power supply (P/N 58027007-00) for indoor-use only is available for the instrument. The power supply has a Hirose connector that connects to the COM/12 V power connector on the front side of the instrument. A power supply cable and four different adapters are available to connect the power supply to the main power in different countries.
NOTE – The power supply must be only used with the supplied power cable that is part of the P/N 58027007-00.
CAUTION – The power supply is intended for indoor-use only and must not be exposed to moisture or liquids.
CAUTION – To avert the risk of an electric shock this device must only be connected to a power supply with a protective earth conductor. The device should be set up so that the power plug can be disconnected from the power supply quickly and easily without any tools. The pull of the power plug is used to disconnect the device from mains.
CAUTION – Use only the power cable and the four adapters (P/N 51695) authorized by Trimble. Any malfunction or damage caused by the use of an unauthorized power cable to the instrument may void the instrument warranty.
Technical data
For the complete technical specifications, please refer to the Trimble X9 3D laser scanner data sheet available from geospatial.trimble.com.
Battery (P/N 99511-30)
|
Supply voltage |
11.1 V DC |
|
Power consumption |
Approximately |
Power supply (P/N 58027007-00)
|
Supply voltage |
Input: 100 to 240 V AC Output: 12 V DC |
|
Frequency |
Input: 47 to 63 Hz |
|
Power consumption |
Input: 1.6 A Output: Maximum 57 W |
