Wi-Fi Status
Select Wi-Fi / Status.
Current Wi-Fi Mode – If the Wi-Fi mode is turned off, this screen displays "Current Wi-Fi Mode: Off". Else, it shows Client and/or Access Point.
Wi-Fi Client Status
See Client Configuration.
Hardware Status – The current status of the Wi-Fi hardware in the receiver.
Region Code – The Wi-Fi region code.
Client MAC Address – The client MAC address.
IP Setup – Depends on the access point; it can be either DHCP (default) or Static IP.
Access Point Status
See Access Point Configuration.
SSID – Service Set Identifier, a 32-character unique identifier attached to the header of packets sent over a WLAN. Also referred to as a network name as it identifies a wireless network.
BSSID – The MAC address of the wireless access point if the receiver is in access point mode and connected to a Wi-Fi network.
Encryption Type – Shows the current encryption type.
Broadcast SSID – Shows the current status. Either Enabled or Disabled.
Transmit Rate – Shows the default setting.
Channel Mode – Shows the default setting.
Channel Number – Shows the current channel number used.
WPA Strict Rekey – Shows if WPA rekey is enabled or disabled.
WPA Rekey Interval – Shows the interval in hours.
Client inactivity timeout – The number of minutes of inactivity from a client connection before it is dropped. The default is 30 minutes.
IP Address – This IP address can be used on an internet browser on a Wi-Fi device if the receiver is in access point mode. In most cases “GNSS” can be entered in the browser.
Netmask – Shows the default setting.
Association list – Shows which devices such as computers or receivers are connected to the receiver that is in access point mode.
