Compliance notices

Australia and New Zealand

This product conforms with the regulatory requirements of the Australian Communications and Media Authority (ACMA) Radiocommunications Act.

Canada

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  • This device may not cause interference.

  • This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

(1) l’appareil ne doit pas produire de brouillage;

(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be chosen so that the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.

Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

This apparatus complies with Canadian RSS-GEN, RSS‑102, RSS‑247.

Cet appareil est conforme à la norme CNR-GEN, CNR‑102, CNR‑247 du Canada.

The UHF (403 MHz to 473 MHz) receiver was tested with a monopole antenna (400 MHz to 512 MHz, -2dBi typical peak gain, TPN44085-60). The connector type is TNC.

Le récepteur UHF (403 MHz à 473 MHz) a été testé avec une antenne monopôle (400 MHz à 512 MHz, gain de crête typique de -2 dBi, TPN44085-60). Le type de connecteur est TNC.

European Union

Hereby, Trimble Inc., declares that the R580 receiver complies with the following directives:

  • RED 2014/53/EU

  • RoHS Directive 2011/65/EU

  • WEEE Directive 2012/19/EU

CE Declaration of Conformity

The products covered by this guide may be operated in all EU member countries (BE, BG, CZ, DK, DE, EE, IE, EL, ES, FR, HR, IT, CY, LV, LT, LU, HU, MT, NL, AT, PL, PT, RO, SI, SK, FI, SE), Norway and Switzerland. Products been tested and found to comply with the requirements for a Radio Equipment device pursuant to European Council Directive 2014/53/EU on EMC, thereby satisfying the requirements for CE Marking and sale within the European Economic Area (EEA). Contains a Bluetooth radio module. These requirements are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential or commercial environment.

Recycling

For product recycling instructions and more information, go to https://www.trimble.com/en/our-commitment/responsible-business/product-compliance/environmental-compliance.

Great Britain (England, Wales, and Scotland)

Hereby, Trimble Inc., declares that the R580 receiver complies with the following UK legislations:

  • S.I. 2016 No. 1101, Low Voltage, RF Exposure

  • S.I. 2016 No. 1091, EMI/EMC

  • S.I. 2017 No. 1206, Radio Equipment

USA

Regulatory model number: R580

FCC Class B - Notice to Users. This device complies with part 15 of the FCC rules.

RESPONSIBLE PARTY:
Trimble Inc.
10368 Westmoor Drive
Westminster CO 80021
USA

www.trimble.com/Corporate/Contacts.aspx

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications made to this equipment not expressly approved by Trimble Inc may void the FCC authorization to operate this equipment.

The UHF (403 MHz to 473 MHz) receiver was tested with a monopole antenna (400 MHz to 512 MHz,-2dBi typical peak gain, TPN44085-60). The connector type is TNC.