Inverse Options

Use these options to calculate and report the azimuth, distance, and other relationships between any two points. They are available in the Inverse command pane.


Options
Show Snap Options	Click this on the Inverse command pane's toolbar to display the Snap Mode dialog, where you can enable and disable running snap modes.
Inverse
From/To	Pick the point in a graphic view, or type a point ID (name) in the field. Or, pick an unnamed scan point. If the Free option is checked in the Snap Mode dialog and you are making your selection on the Plan View tab, you can also pick a location where there is no point (not applicable on a 3D View tab or Station View tab). In this case, only 2D inverse values are calculated.
	Sequential – Data is collected in a line, and you want to verify distances around the traverse. For example, you will need to click on: A to B, B to C, C to D, D to E, and E to A. Radial – Data is collected in a ray, and you want to check distance from the base station. For example, you will need to click on: A to B, A to C, A to D, and A to E.
Reported points
Show Report	Click this to display the Inverse Results report in your default web browser.
Report Options	Click this to display the Report Options command pan, in which you can specify heading, footer, and format settings for the Inverse Report.
From point ID/ To point ID	Click in the first column of any row tolist details for the inverse of the points.
Details	This shows the azimuths, changes in elevation and height, and three distances of the selected inverse: Grid Ellipsoidal Ground
Apply	This acts as the [Enter] key, when specifying points, moving the focus between From, To, and Reported Points.