Enter an Angle

Use the Angle control to enter an angle by specifying a bearing in relation to the default bearing. The default bearing (and zero angle) is east. Positive angles are measured counter-clockwise from 0 to <360 degrees. "Angle" appears on the Status Bar when the command is active.

Angle controls are used in these snap commands:

Bearing + Angle Snap
Point to Point Bearing Snap

Angle controls give you access to these snap commands on the context menu:

Deflection Angle Snap
Three Point Snap

To specify an angle:

Pick an anchor point in a graphic view. With the cursor "rubber-banding" from the default bearing, pick another point to specify the angle.
Type a value in the Anglebox, using one of the standard entry formats. Check and set the entry format in Project Settings by selecting Project Settings> Units > Angular.
Right-click in a graphic view, select a snap command from the context menu, and specify the necessary parameters.